Manage water responsibily and reduce operating expenses

When precision irrigation decisions count, the FieldScout TDR Series offers growers a tool to eliminate the guesswork. Based on proven time-domain measurement technology, these portable units accurately measure soil moisture across the full range of soil moisture conditions. Select from the 1.5***, 3, 4.8 or 8-inch (3.8***, 7.5, 12 or 20-cm) probe rods to suit your desired depth measurement. Install PVC access tubes and take readings deeper in the soil profile.

The TDR 300 has two volumetric water content modes; one for standard soils and one for higher clay soils. In volumetric water content (VWC) mode, the meter converts a measured electrical signal into percent soil moisture content using an equation valid over a wide range of mineral soils. In irrigation mode, the meter displays a relative water content (RWC) on a scale of 0 to 100 corresponding to a user-defined upper and lower soil moisture reference level. Water deficit, the amount of water needed to bring the soil moisture content up to the upper reference level, is also calculated and displayed. The reference levels are easily programmed into the meter with the accompanying software. Create up to 2 management sites based on your soil types and crop needs. Use the raw reading mode (measurement period in microseconds) to do soil-specific calibrations.

Perfect for Researchers and Consultants! An internal data logger and RS-232 port allow for use with a DGPS for geo-referenced soil moisture measurements. Includes software and PC cable*.

Use the powerful SpecMaps online application to discover the value of spatially variable sensor measurements. Mapping software requires GPS**; not included.

RODS ARE SOLD SEPERATELY. For more information on the TDR Rods.

* Spectrum’s PC cables connect to a 9-pin serial port. USB-Serial adapter (item 3661USB) required for connection to computers with only USB ports. ** GPS interface requires two cables. The GPS/DGPS cable (item 2950CV5) is available from Spectrum. A PC serial interface cable supplied by the manufacturer of the GPS receiver is also required. *** 1.5" (3.8 cm) rods may require a TDR 300 firmware update. Please contact us for instructions.